 | | Re: sonar
|
|
The location(C7) for the .1uF that you are refering to is located on the sonar driver board, on the lower left corner of the ribbon connector. Any non-polarized cap will do just fine. (...) (27 years ago, 24-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | Re: colour sensor
|
|
An optical sensor with a filter in front of it. Standard photocell works fine. Three of them, each with a red, green, and blue filter and then sampling the three inputs can be very flexible. --Chuck (...) (27 years ago, 23-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | RE:color sensor and Vision any one?
|
|
(URL) sells a relatively cheap camera/frame grabber package named the ramcam. you access it directly and treat it like a ram chip. The color vision would proboly be easy to interface as a color sensor. And To you Handyboarders out there, would this (...) (27 years ago, 23-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | colour sensor
|
|
what kind of sensor can i use to determine the colour of a surface. cheers fazal (27 years ago, 23-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | Re: sonar
|
|
(...) I would imagine that this is the case since Fred states on his page that it won't work without it on most versions of the driver board. The easiest way to do it is just desolder the two pads that align with the c7 position on the HB. Stick a (...) (27 years ago, 23-Jan-00, to lugnet.robotics.handyboard)
|
