 | | Refresh-rate of GP2D12
|
|
Hi, there is a new datasheet available for Sharps GP2D12-device. The refresh rate is definetely worse than 32ms as posted before, the correct (worst case) value is about 53 ms. See: (URL) for details DIRK (27 years ago, 18-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Robotics Show on TLC
|
|
(...) Thank you for this pointer. I taped it (locally it was at 2am Sunday!) and we found it very interesting. I especially like the wheel design behind the JPL Nanorover ((2 URLs) (27 years ago, 17-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | How to connect handy board with linux
|
|
Hi, I have a problem, I wish someone can help me. I use linux to control my handy board. I can type command under IC, but I can do nothing without IC. HOw can I do something out of IC? Like type some command in another terminal? Your help will be (...) (27 years ago, 17-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | Can't get input capture to work
|
|
I'm hoping someone can help me figure out the problem with the following driver. Ultimately I want to simulate a sony IR remote control using a 6.270 board. I acquired the sony-ir.asm and tried it out, but that wasn't working; so I trimmed it down (...) (27 years ago, 17-Jan-00, to lugnet.robotics.handyboard)
|
| |
| | Re: Lego-izing the Handyboard.
|
|
Mark -- I built a chassis for my robot that cradles the HB and clamps two Lego gear motors solidly in place. Check out this web page for photos: (URL) side of the chassis consists of two sixteen-unit beams, one on top of the other with two-unit (...) (27 years ago, 17-Jan-00, to lugnet.robotics.handyboard)
|
