 | | Using Servo motors
|
|
I was trying to connect a servo motor to the HB as indicated in the technical reference but found a small problem. The wires of my servo are not color coded as red black and white but as red black black. Is there anyway I could find out which of the (...) (29 years ago, 18-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | compiler eror...
|
|
hi, could someone tell me whats a 'yacc stack overflow' compiler error mean?? i had written a long series of 'if-then-else' statements, and each statement was to invoke the motor(int,speed) function... thanks Sriram (29 years ago, 18-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | Wheel Shaft Encoders
|
|
(...) Hello, I'm new to the Handy Board mailing list. I have been browsing through the archives and I saw the discussion regarding shaft encoders. I haven't seen anyone use the technique I've used rather well. Like the thread suggests, I've tried (...) (29 years ago, 18-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | Infrared Detectors
|
|
Hi everybody I'm looking for infrared detectors/emitters for collision avoidence on my robot. can anyone reccomend any? they only need to shoot maybe 2 feet or so, just to pick up ground-lying things the sonar might miss. any help is (...) (29 years ago, 18-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | Shaft Encoders
|
|
(...) Hello, I'm new to the Handy Board mailing list. I have been browsing through the archives and I saw the discussion regarding shaft encoders. I haven't seen anyone use the technique I've used rather well. Like the thread suggests, I've tried (...) (29 years ago, 18-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | (no subject)
|
|
unsubscribe handy board wcm@tbscc.com ---...--- Nicholas Willam McQuiston General Geek <wcm@tbscc.com> (29 years ago, 17-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | POWER GLITCH msg
|
|
for edification, Oriol reported that the problem was loading the wrong pcode... -Fred ------- Forwarded Message (29 years ago, 17-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | Servo information
|
|
Can somebody tell me the power requirements for a SANWA SRM-101 servo that I took from a RC car ? Thanks Oriol (29 years ago, 16-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | RE: -POWER GLITCH- message
|
|
(...) One possibility: make sure you have loaded pcode_hb.s19 onto the board, and *not* pcoder22.s19. I've reloaded the correct version of the IC into the HB and it looks like it works fine. Thanks again Oriol ------- End of Forwarded Message (29 years ago, 16-Aug-96, to lugnet.robotics.handyboard)
|
| |
| | Re: -POWER GLITCH- message
|
|
One possibility: make sure you have loaded pcode_hb.s19 onto the board, and *not* pcoder22.s19. when you say "even if I don't move the HB at all after runing for a few seconds the HB usually crashes" do you mean, it crashes with the "-POWER GLITCH-" (...) (29 years ago, 16-Aug-96, to lugnet.robotics.handyboard)
|
