|
|
 | | Motor driver circute problem Using L298N
|
| Hi guys, I built a Hbridge motor driver using the IC L298N. But it is not working properly. It is swithcing properly with the inputs but it is not drawing the current required for the motor. I am sensing the out Voltage as 8v but when i connect the (...) (25 years ago, 21-Dec-99, to lugnet.robotics.handyboard)
| | | | | Re: Advice
|
| Need more information. What kind of "light" sensors are you referring to? CdS cels, IR light sensors, active sensors? There is alot of information on wiring sensors in the Handyboard manual available in the Documentation section of the MIT (...) (25 years ago, 20-Dec-99, to lugnet.robotics.handyboard)
| | | | | Advice
|
| How do I connect the light sensors to the board correctly? Cheri Burch (25 years ago, 20-Dec-99, to lugnet.robotics.handyboard)
| | | | | Re: Futaba or Hitec servos
|
| (...) As always with the "what is better" question, I must ask... What do you mean by "better"? They will operate the same, I think they have the same cable pinout. The Hitec ones are cheaper usually, but a little larger for the same specs. At the (...) (25 years ago, 19-Dec-99, to lugnet.robotics.handyboard)
| | | | | Re: Shaft Encoders
|
| (...) While I am not familiar with the LEGO Rotation Sensor (simply because I havn't got one yet), I have constructed, for the moment, a "homebrew" rotation sensor. My recent models have mostly been models of the robots we build at work. They are (...) (25 years ago, 18-Dec-99, to lugnet.robotics, lugnet.robotics.handyboard)
|
|
