|
| | Re: servo motor design
|
| If you are using a Handyboard then what you probably want to do is simulate a servo motor rather than actually go through the effort of building one that behaves like the ones from a hobby shop. As an example, if you had a lego motor driving a gear (...) (25 years ago, 16-Dec-99, to lugnet.robotics.handyboard)
| | | | servo motor design
|
| I know that designing your own servo motor is kinda stupid becoz they are abundant out there. but i'm in a competition which requires us to design our own gearbox, so i don't see a way out of it. how do i start? how do i design that feedback loop (...) (25 years ago, 15-Dec-99, to lugnet.robotics.handyboard)
| | | | (no subject)
|
| unsubscribe (25 years ago, 15-Dec-99, to lugnet.robotics.handyboard)
| | | | Re: Driving an L298 motor driver board
|
| Hi, I done a PCB with the L298 H-Bridge. You just need to remove the L293D and but a special connector in the socket. You can drive motors (2) with 2A current. If you are interesting with this PCB send me a mail. kind regards, Nicolas. (25 years ago, 14-Dec-99, to lugnet.robotics.handyboard)
| | | | Re: error message
|
| Sorry, but Interactive C does not support the "case" construct. You'll have to rewrite your code using "if...then" statements. Ross M. Tonkens, M.D. Medical Director Primary Care of Nevada 100 North Green Valley Parkway Suite 240 Henderson, NV 89014 (...) (25 years ago, 14-Dec-99, to lugnet.robotics.handyboard)
| |