| | (no subject)
|
|
unsubscribe handy board wcm@tbscc.com ---...--- Nicholas Willam McQuiston General Geek <wcm@tbscc.com> (28 years ago, 17-Aug-96, to lugnet.robotics.handyboard)
|
|
| | POWER GLITCH msg
|
|
for edification, Oriol reported that the problem was loading the wrong pcode... -Fred ------- Forwarded Message (28 years ago, 17-Aug-96, to lugnet.robotics.handyboard)
|
|
| | Servo information
|
|
Can somebody tell me the power requirements for a SANWA SRM-101 servo that I took from a RC car ? Thanks Oriol (28 years ago, 16-Aug-96, to lugnet.robotics.handyboard)
|
|
| | RE: -POWER GLITCH- message
|
|
(...) One possibility: make sure you have loaded pcode_hb.s19 onto the board, and *not* pcoder22.s19. I've reloaded the correct version of the IC into the HB and it looks like it works fine. Thanks again Oriol ------- End of Forwarded Message (28 years ago, 16-Aug-96, to lugnet.robotics.handyboard)
|
|
| | Re: -POWER GLITCH- message
|
|
One possibility: make sure you have loaded pcode_hb.s19 onto the board, and *not* pcoder22.s19. when you say "even if I don't move the HB at all after runing for a few seconds the HB usually crashes" do you mean, it crashes with the "-POWER GLITCH-" (...) (28 years ago, 16-Aug-96, to lugnet.robotics.handyboard)
|