| | Excessive clutziness when replacing the NiCad battery pack
|
|
Hello, everyone: I'm having problems when I replace the HandyBoard's NiCad battery. I have probably replaced around 10 battery packs by now on different HandyBoards. On 4 or 5 of the replacements, I end up having to replace the 74HC373 latch, (...) (25 years ago, 7-Dec-99, to lugnet.robotics.handyboard)
|
|
| | synchronization error
|
|
I'm encountering a synchronization error when calling serial_putchar within a for loop. Here's my code: void test(){ int looper; for (looper=0;looper<16;looper++){ if (looper<7){ serial_putchar(analog(looper)); printf("\nPort: %d Value: (...) (25 years ago, 7-Dec-99, to lugnet.robotics.handyboard)
|
|
| | Re: Another chance for the LM35
|
|
(...) Well, di you try to put an Operational Amplifier mounted in voltage following? +Vcc --- Op. Amp. | *-------* LM 35 O------|+ Vin | | | Vout|--\----- To 68HC11 Analog Port --- /-|- Vin | | GND \\\ | *-------* | \---...---/ Florent (25 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|
|
| | Stepper motor
|
|
Does anybody know whether it is advisable to control a 24VDC stepper motor using the handyboard's motor outputs (11V)? also, what's the maximum phase current the motor can have to be compatible with the handyboard? (25 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|
|
| | Stepper motor
|
|
Does anybody know whether it is advisable to control a 24VDC stepper motor using the handyboard's motor outputs (11V)? (25 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|