 | | Re: Another chance for the LM35
|
|
(...) Well, di you try to put an Operational Amplifier mounted in voltage following? +Vcc --- Op. Amp. | *-------* LM 35 O------|+ Vin | | | Vout|--\----- To 68HC11 Analog Port --- /-|- Vin | | GND \\\ | *-------* | \---...---/ Florent (27 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | Stepper motor
|
|
Does anybody know whether it is advisable to control a 24VDC stepper motor using the handyboard's motor outputs (11V)? also, what's the maximum phase current the motor can have to be compatible with the handyboard? (27 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | Stepper motor
|
|
Does anybody know whether it is advisable to control a 24VDC stepper motor using the handyboard's motor outputs (11V)? (27 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | IR files and sensors
|
|
Two question i have: 1. On the Handyboard webpage, there're the files for the IR Remote Control software. it's a little long and complicated. i'm purely interested in activating the output ports and modulating it to transmit the 40khz signal and (...) (27 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | Another chance for the LM35
|
|
Hi, I'm again trying to connect the LM35 from National, there was some posts in the list, but none of that solve my problem. As an introduction let me say that the sensor provides an output of 10 mV/ ° C at 10 mA, the conversion when reading it (...) (27 years ago, 6-Dec-99, to lugnet.robotics.handyboard)
|
