 | | IC Technical Support problem
|
|
Hi! I bought my first handyboard in mid October and a Rug Warrior Pro in early November. And since I have had this peculiar download problem with the IC 3.2, pcode will download without any problems but everytime after downloading the lib files, IC (...) (27 years ago, 5-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | Re: strange TS-53 servo problem
|
|
Hi ... It sounds as though you are obtaing the power for your servo from the HandyBoard's motor output pins ... and if so, this is the source of your problem. The HB does NOT control motor speed by varying the DC level ... it uses PWM to reduce the (...) (27 years ago, 4-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | strange TS-53 servo problem
|
|
Since the output ports for the motors of the handyboard supplies 11V, i connected a 5V regulator to power my servo. i have a capacitor between the driver's + and - terminals. I looked at the control signal on the oscilloscope. The duration of the (...) (27 years ago, 4-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Virus
|
|
Hi - Yes very well said -- on top of that HE may have been infected and we were the result of that infection. Sure can't see a guy putting out a virus with his name address phone and photo on it unless he is some really sick sucker! Regards - Dave (...) (27 years ago, 4-Dec-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Suggestions for Virus Management
|
|
Hi - Yes I too received this virus - I did not open it though. We had a copy of it sent to where I work so I knew of it. I hope that very few of you got infected. Regards - Dave ----- Original Message ----- From: Evil Mechatron (...) (27 years ago, 4-Dec-99, to lugnet.robotics.handyboard)
|
