 | | Re: IC 3.X and Smooth PWM
|
|
Yes it does. Look in the Handy_Board_1.2.icd file that came on your 3.x disc. That file specifies the .s19 pcode file to load and any other files to be loaded at startup of IC 3.x. You can either change those to some special name you have created (...) (25 years ago, 26-Nov-99, to lugnet.robotics.handyboard)
|
| |
| | IC 3.X and Smooth PWM
|
|
Does IC 3.X support smooth PWM? (25 years ago, 26-Nov-99, to lugnet.robotics.handyboard)
|
| |
| | Re: motor driver circuit -- help needed
|
|
Hi, my name is nicolas and I'm a french student in an engineering school at LYON. I make a PCB with the L298N for the handy board. You must remove the L293D that you use for the motor 0 and 1. You put a connector in the socket 16 pin and this (...) (25 years ago, 25-Nov-99, to lugnet.robotics.handyboard)
|
| |
| | motor driver circuit -- help needed
|
|
Hi , I am trying to drive two DC motors of 12v, 2A rating for my robot base. I am looking for the ready-made motor drivers for this. Please sujust me if you guys have any products known. i found one in the web , help me in deciding whether this is (...) (25 years ago, 25-Nov-99, to lugnet.robotics.handyboard)
|
| |
| | Re: HandyBoard not responding
|
|
Hi, Finally I found out what happened. One of the pins of the RJ-11 socket on the handyboard was disconnected from the PCB. So I soldered it back and the handyboard is working fine. Thanks for all your help. Kalyan (...) (25 years ago, 25-Nov-99, to lugnet.robotics.handyboard)
|
