|
|
 | | Re: Servo question
|
| (...) You need to go into the servo.c file, and adjust the minimum and maximum frequencies the servo can handle. If you open servo.c, you'll find instructions as to how to do this. You pretty much just have to adjust the program to suit your servo, (...) (28 years ago, 10-Aug-96, to lugnet.robotics.handyboard)
| | | | | Servo question
|
| hello everyone I'm playing around with a servo on the HB. i loaded all the progs and got it to twirl, but it won't do a full 180 degrees. i'm just using the servo() command. i suppose servo(1400) is supposed to point it 0degress, but it points about (...) (28 years ago, 10-Aug-96, to lugnet.robotics.handyboard)
| | | | | Re: bootstrap quirk
|
| (...) Thanks for the suggestion. Unfortunately, the behavior is the same regardless of whether the interface board is connected to my computer. (...) I believe it is working fine, as the previous tests of it were passed. I did have a problem where (...) (28 years ago, 10-Aug-96, to lugnet.robotics.handyboard)
| | | | | (no subject)
|
| More MUSINGS follow. Seeing as my job gets progressively more MANAGEMENT than TECHNICAL these days - is it really inevitable over the years?? - this software/electronic/mechanical exercise called robotics seems a good hobby to do all those things (...) (28 years ago, 9-Aug-96, to lugnet.robotics.handyboard)
| | | | | Re: IR transmission
|
| (...) Well actually, even though it's not a precision resistor, when I installed it, I grabbed a bunch of resistors and measured each one with my DMM until I found one which was between the 3.74 and 3.83 values Fred specified. To further test this, (...) (28 years ago, 8-Aug-96, to lugnet.robotics.handyboard)
|
|
