 | | Re: GP2D05 (correction)
|
|
I apologize for the previous mail on the GP2D05 subject. The information I gave was base on my careless assumption (duhh) which was also wrong. Once again, I am sorry for any inconvenience. =o( Rob (25 years ago, 27-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Re: GP2D05
|
|
I am using the GP2D02 which is also identical to the GP2D05 except that on the GP2D05 you can manually set the threshole using the built-in trimpot. I am using Barry Brouillet driver for interfacing to the Handyboard/w expansion board and it works (...) (25 years ago, 27-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Not necessarily the handyboard....
|
|
I have an old 486 laptop and a few motors and sensors lying around...Does anyone know of a DSP board or some other device I could use to interface the motors and sensors to the laptop for real- time data aquistion? (I already have my handyboard (...) (25 years ago, 27-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Re: stalled motor detection
|
|
If a motor stalls, it draws a lot of current (compared to normal operation). You can measure that quite easilyusing dedicated chip, or by measuring the voltage over a small resistor in series with the motor: if more current is draw, the voltage drop (...) (25 years ago, 27-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Re: stalled motor detection
|
|
Shaft encoders are hard to beat. If the wheels are commanded to turn and aren't, that's a good indication that something is screwy. Plus, if you're doing dead reckoning, you need them anyway so they are already there! Gary Livick (...) (25 years ago, 27-Oct-99, to lugnet.robotics.handyboard)
|
