 | | for loop stack overflow
|
|
THis may be a dumb question on my part, but we are getting stack overflows on for loops such as for(int i = 0;i<1000;i++){...} when using values over 100 or so. Is this an 8bit counter thing or something else? Thanks, Owen Popplestone (25 years ago, 20-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Handyboard low voltage motor control
|
|
Well, I went with separate h-bridge to maintain PWM and it turns out that even though the motors are geared down, they still don't have enough torque to haul around all the batteries. Looks like I'll stick with 9v motors... Thanks for the (...) (25 years ago, 20-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | RE: port addresses
|
|
This is the online ordering form for motorola literature (if you are looking for motorola manuals) (URL) Message----- From: SNESS@amcomp.com [mailto:SNESS@amcomp.com] Sent: Wednesday, October 20, 1999 10:27 AM To: jimmn@xnet.com; (...) (25 years ago, 20-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | GLOBAL POSITIONING SYSTEM
|
|
I learned that somebody has successfully connected GARMIN GPS to HB. If I am not wrong , this GPS is not be able to receive any signal in building. If this the case, GPS is only good for outdoor robotics. Another thing is about the accuracy of the (...) (25 years ago, 20-Oct-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Vector 2x
|
|
I know everyboard has been sucessfully connected vector 2x to hb. I try to do the same thing as per Tom Brusehaver guides. Connecting as below :- +5V (SPI) to VCC (vector2x) GND(SPI) to GND (vector2x) MISO(SPI) to SDI (vector2x) MOSI(SPI) to (...) (25 years ago, 20-Oct-99, to lugnet.robotics.handyboard)
|
