| | Re: Error at address 0x0000
|
|
Hello, i have the same problem with the Error at address 0x0000. First i checked the hardware (Ram,Latch...) but i cant't find a bug. In the archive i found this message that descibe a softwarebug on faster machines. But i tested HBDL with a P133 (...) (25 years ago, 12-Oct-99, to lugnet.robotics.handyboard)
|
|
| | Stepper Motors
|
|
Can anyone give me a sample program on how to control a stepper motor and were is a good place to but some that work good with the handy board. TIM ===== (25 years ago, 11-Oct-99, to lugnet.robotics.handyboard)
|
|
| | Re: Handyboard/ USB interface
|
|
i have tested several of these with Macintosh. I haven't tested any with PC, but i assume they should work. see (URL) for info on the Mac solutions. f. In your message you said: (...) d (...) (25 years ago, 11-Oct-99, to lugnet.robotics.handyboard)
|
|
| | Handyboard/ USB interface
|
|
I have heard of USB to RS232 adapters- I was wondering if anyone has had any luck in using these devices to connect to the Handyboard? I recently purchased a new computer, but it only has 4 USB ports, and no RS232 ports!. (25 years ago, 11-Oct-99, to lugnet.robotics.handyboard)
|
|
| | RE: LM35 Again
|
|
Hi, Like an update to my prior email, I have tested the LM35 with an external power source, with the same bad result. Any help will be welcome. Thank You José Luis ----- Original Message ----- From: Jose Luis <hal9000@cvtci.com.ar> To: (...) (25 years ago, 11-Oct-99, to lugnet.robotics.handyboard)
|