 | | Re: error when loading *.icb file
|
|
this is a known problem. see the FAQ: (URL) your message you said: (...) (27 years ago, 24-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | Re: error when loading *.icb file
|
|
I had the same problem. When I run as11-ic on my MAC, I have no problem. When I do it on an IBM clone, I cannot load it into the Handy Board. I fixed it by hand-editing out the comment line (its in human language) in the generated .s19 file and it (...) (27 years ago, 24-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | EXTENSION BOARD
|
|
I every one, I have a problem, is it possible to have an extension board connected to the HB, and at the same time have a seperate motor power source? The reason I'm asking this is because that the "seperate motor power source" and "extension board" (...) (27 years ago, 24-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | error when loading *.icb file
|
|
Hi, I have downloaded the as11 assembler. When I assemble a *.asm file, a *.icb file was created. Then I whated to load the file in the HB but the message "Fatal internal error: Illegal line in .s19 file" was dispayed on the monitor. What's the (...) (27 years ago, 24-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | No objection
|
|
Gary Livick wrote: <snip> (...) I don't mind that sort of solicitation. I think it's great that you're helping the Handy Board community by developing HB robotics accessories. I might end up being a customer when you get it up & running. Good luck (...) (27 years ago, 24-Sep-99, to lugnet.robotics.handyboard)
|
