|
| | Re: OVER 1 AMP
|
| (...) www.yahoo.com, search for "H Bridge", trust me, lots of hits will comeup. Look for the 4QD pages, they talk a lot about H Bridge designs. If you aren't comfortable with electronic design, don't bother though... (...) This IS an H Bridge. Its a (...) (25 years ago, 23-Sep-99, to lugnet.robotics.handyboard)
| | | | OVER 1 AMP
|
| Now, I recieved two good answers for my problems. 1) Built an H-Bridge 2) Use the LMD18200 Now has any one any documentation on an easy H bridge that I could build without wasting much time? The same goes for the LMD18200, I understand that is not (...) (25 years ago, 23-Sep-99, to lugnet.robotics.handyboard)
| | | | Re: before I reinvent the wheel
|
| No, but I have used my HP48sx to control the Fascinating Electronics board as well as an NRD535 shortwave receiver. The serial I/O of the HP48 is limited to shield, ground, tx and rx pins so in both cases I had to wire special cables to jumper (...) (25 years ago, 23-Sep-99, to lugnet.robotics.handyboard)
| | | | Re: Source for IS1U60
|
| Hi Igor - - When you need to locate parts, try this link: (URL) found a couple of sources for the IS1U60 through them. - Nick - (...) (25 years ago, 23-Sep-99, to lugnet.robotics.handyboard)
| | | | Re: Source for IS1U60
|
| (...) Addendum to my last post. For my money, I would get the LiteOn unit instead. Its less fragile (nifty metal can) and has the same pinout as the Sharp GP1U58Y units, and you can get them in a variety of frequencies at (URL) Part Number 160-1153, (...) (25 years ago, 23-Sep-99, to lugnet.robotics.handyboard)
| |