 | | Source for IS1U60
|
|
Hi! Can anybody point me to a mail order company who carries the Sharp IS1U60 infrared demodulator? Thanx...Igor (27 years ago, 23-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Good place to but miniboard?
|
|
(...) First off, how much are you looking to pay? It can be built fairly cheaply if you are interested. Second, there is a mailing list for the miniboard. Check out Fred Martin's FTP site relating to the miniboard for the details. It's all in there. (...) (27 years ago, 22-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | Good place to but miniboard?
|
|
hi Was just wondering if you guys now of a cheap place to buy a miniboard(kit or assemebled) or if any of you are willing to part with one you have lyeing around the shop. Also is there a mailing list like this one for the Miniboard? Has any one (...) (27 years ago, 22-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | Re: before I reinvent the wheel
|
|
Doh! I should have said I was planning on using IR, but a serial cable makes more sense (at least to start with)... Thanks, Paul Adam Oliver wrote in message <001401bf04c9$2bdb67...c@adam>... I haven't actually done this, but I'm pretty sure the (...) (27 years ago, 22-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | differential steering
|
|
Hi, I what to built a four wheeled robot which uses differential steering. Have somebody an idea to transfer the motion energy from the motor powered back wheels to the front wheels? Jens (27 years ago, 22-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | Re: before I reinvent the wheel
|
|
before I reinvent the wheelI haven't actually done this, but I'm pretty sure the theory is ok... On the handyboard web page is the pa79600 icb file which lets you use port a bit 7 as serial i/o. I have successfully used this to control some (...) (27 years ago, 22-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | before I reinvent the wheel
|
|
Has anyone used their HP48 to talk to a handyboard? (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | Using 12V supply with Expansion Board?
|
|
Hello 'Botter, I think I am about to ask a stupid question but as a precaution, will the Expansion board be "ok" with a new 12V motor supply rather than the 9.6V connected to the Power Expansion header (J13)on the HB since the Expansion board and HB (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
|
| |
| | (canceled)
|
|
|
| |
| | Re: Shaft encoder
|
|
(...) The shaft encoder library routine available from the Handy Board web site works great for me. Just follow the links to Software, then Libraries, then Shaft encoders. Good luck! -- Will , , __@_/ \_@__ |/ | /__, o @_/ )\ ) ( \ (\/\\, ~~~...~~~ (...) (27 years ago, 21-Sep-99, to lugnet.robotics.handyboard)
|
