 | | Re: VOLTAGE AND CURRENT
|
| the car will almost undoubtedly fry the motor driver on the HB, and having it on the same power will probably generate enough noise to occasionally reset the HB. best bet would be to have the car use its own power and h-bridges, with the control (...) (27 years ago, 8-Sep-99, to lugnet.robotics.handyboard)
| | | | | Re: VOLTAGE AND CURRENT
|
| First of all - get rid of the CAPS LOCK!!! Second of all, if your RC Car draws a Max Current of 3.5 Amps then you'll blow the motor drivers on the handyboard since they're only spec'd to provide 1 A. If the RC car starts asking for more current then (...) (27 years ago, 8-Sep-99, to lugnet.robotics.handyboard)
| | | | | Re: Error at address 0x0000
|
| This was the case for the error that I was getting. I switched to a slower machine and things worked after that. -Jake ---...--- Forwarded by Jacob Levirne/Trilogy on 09/08/1999 03:57 PM ---...--- "Dvorak Viktor" <dvorakv@cesnet.cz> on 08/28/1999 (...) (27 years ago, 8-Sep-99, to lugnet.robotics.handyboard)
| | | | | Error at address 0x0000
|
| Hi, I saw that some else also had this error when trying to download to the board in section 6 of the manual. I am also getting this error. I have tried replacing the memory chip, the address hold chip, and the NAND gates. None of this has helped. I (...) (27 years ago, 8-Sep-99, to lugnet.robotics.handyboard)
| | | | | VOLTAGE AND CURRENT
|
| SIMPLE QUESTION TO ANYBODY: I'M PLANNING ON INTERFACING THE HANDY BOARD WITH AN R/C CAR. NOW THE MOTORS OF THE R/C CAR DRAW 1 AMP CONTINUOUSLY, AND A PEAK CURRENT OF 3.5 AMPS. THE R/C CAR USES A 9.6 VOLT BATTERY. NOW , ACCORDING TO HANDYBOARD (...) (27 years ago, 8-Sep-99, to lugnet.robotics.handyboard)
|
|
