 | | Re: Voice Recognition Hardware
|
|
Try to track down a company called "CoVox". These guys used to have a speech recognition device that ran on the Apple II (6502) that was pretty cool (speaker dependent of course). Also there is a speech recognition chip for use in toys the HM002 or (...) (25 years ago, 26-Jul-99, to lugnet.robotics.handyboard)
|
| |
| | Voice Recognition Hardware
|
|
Greetings All! I was wondering if anybody out there knows of any good, relatively inexpensive, (<$350) Voice recognition hardware that is relatively easily interfaced to the handy board? Thank you very much. -Ryan Meuth (25 years ago, 26-Jul-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Weak Motor
|
|
(...) I remember someone saying a few months ago that if you use a 12 V battery with the HB, then the HB's built-in charging circuit won't work properly, and that 12 V batteries can initially deliver up to about 14 V, which wouldn't be very kind to (...) (25 years ago, 25-Jul-99, to lugnet.robotics.handyboard)
|
| |
| | Re: something is wrong with my handyboard
|
|
I had a similar problem. In my case, the cause was underneath the board. I had not trimmed one of the components leads enough. When I screwing the board into the case the lead eventually pierced one of the wires going to my Nicad pac. My board would (...) (25 years ago, 25-Jul-99, to lugnet.robotics.handyboard)
|
| |
| | Re: HB Serial line speed change
|
|
(...) Note that this will also require that you disable interrupts, and that will mess up your motors. However, it should be possible. --Chuck (25 years ago, 25-Jul-99, to lugnet.robotics.handyboard)
|
