 | | Re: speed control help
|
|
lroska wrote: <snip> (...) <snip> (...) <snip> (...) <snip> The easy solution is to avoid using a formula that assumes anything about the motor speed curve (except of course that reducing the motor value reduces the speed). Try using a feedback (...) (25 years ago, 23-Jun-99, to lugnet.robotics.handyboard)
|
| |
| | speed control help
|
|
I have a problem that involves speed control. My robot is curently configured for differential steering and have shaft encoders installed on each one for feedback. the shaft encoders generate 64 pulses /rev The motors are PWM using the rug warrior (...) (25 years ago, 23-Jun-99, to lugnet.robotics.handyboard)
|
| |
| | serial interface building
|
|
A group of us are building the HB and we are at the serial interface building stage. When we perform the test on the serial interface to get +9 or +10 volts, we are all getting values of up to +8.5 only. Is there a problem or is this normal? Thanks (...) (25 years ago, 22-Jun-99, to lugnet.robotics.handyboard)
|
| |
| | GP2D02
|
|
I am having trouble getting the IR sensor to show values on the LCD screen. I am confident that it is finally hooked up correctly. The following is what is included in the list file to automatically download into the board: explego.icb lib_hb.icb (...) (25 years ago, 22-Jun-99, to lugnet.robotics.handyboard)
|
| |
| | runtime errors
|
|
What are the meanings of the various runtime errors? Thus far I have gotten 3 and 4, but I am curious as to what the rest are as well. =) Andrea (25 years ago, 22-Jun-99, to lugnet.robotics.handyboard)
|
