 | | Re: IS1U60
|
|
(...) The Sharp GP1U5x series. Of course, this is the same manufacturer, so you may still have the same problem... Duncan (27 years ago, 16-May-99, to lugnet.robotics.handyboard)
|
| |
| | Memory Problem?
|
|
I am in the downloading step on building a HandyBoard, I use the windows Handyboard download program, to download the pcode_hb.s19 file. All the process looks right, but in the Handyboard nothing happends. What can I do? Is it the 32k memory? Does (...) (27 years ago, 16-May-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Miniature Stepper Motors
|
|
I propose you to review technical specification of "light servo" system for RC airplane of following web site. (...) (27 years ago, 14-May-99, to lugnet.robotics.handyboard)
|
| |
| | Miniature Stepper Motors
|
|
This is more of a general question about the size and resolution of stepper motors and linear actuators. Basically, I was wondering if anyone has any experience with very small high resolution actuators. I am trying to find out if stepper motors on (...) (27 years ago, 14-May-99, to lugnet.robotics.handyboard)
|
| |
| | IS1U60
|
|
Hi, im building the handy board and i wonder if you know some substitute for the IS1U60 infrared demodulator. Thanks a lot for you help. Sincerely yours Eduardo Gonzalez Ramirez (27 years ago, 14-May-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Servo Control Documentation Clarification...
|
|
Andre: You're right about the HandyBoard & expansion board documentation not being correct in its servo entries. I don't recall what values I found to work properly on the bare HB, but on the expansion board the default of 2540 comes close to (...) (27 years ago, 14-May-99, to lugnet.robotics.handyboard)
|
| |
| | Servo Control Documentation Clarification...
|
|
Hi, While I was trying to produce .85, 1.35, and 1.85 millisecond pulses with the Handy Board (with *and* without the expbd.), to control Team Novak's ((URL) "Super Rooster" Electronic Speed Controller (ESC), I found the following discrepancies (...) (27 years ago, 14-May-99, to lugnet.robotics.handyboard)
|
| |
| | IR routines
|
|
Hi Max: I used your IR routines with the HandyBoard. I was wondering if it is possible to do something like that for the RUG Warrior, 'cos it also uses the similar IR receiver ( GP1U52X ) . The port to which the sensor is connected is different ( (...) (27 years ago, 13-May-99, to lugnet.robotics.handyboard)
|
| |
| | MC34064
|
|
Can anybody tell me the pins config in the MC34064, because I am using the MC34064 as a susbtitute of the DS1233. Thanks Daniel ---...--- " `BETTER´ IS THE ENEMY OF `GOOD ENOUGH´" ---...--- (27 years ago, 13-May-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Unsubscribe (Geez, again?)
|
|
(...) My apologies to those smart enough to know better... Fred Martin must have mailed that unsubscribe reminder to me only. I remember seeing it just a day ago, but since there are so many people burning up bandwidth by sending requests to the (...) (27 years ago, 12-May-99, to lugnet.robotics.handyboard)
|
