 | | Re: Minissc 2
|
| If you've loaded the pa7i9600 file, you need to use these lines: pa7i9600(255); pa7i9600(0); pa7i9600(127); which should move servo number 0 to position 127 (the centre position). Probably better if you use something like 255 or 0 to get it to move (...) (27 years ago, 12-May-99, to lugnet.robotics.handyboard)
| | | | | Unsubscribe Unsubscribe Unsubscribe Unsubscribe Unsubscribe Unsubscribe
|
| (27 years ago, 12-May-99, to lugnet.robotics.handyboard)
| | | | | Unsubscribe
|
| Please unsubscribe me from the handy board mailing list. Alex Novaes (27 years ago, 12-May-99, to lugnet.robotics.handyboard)
| | | | | Minissc 2
|
| (...) (27 years ago, 12-May-99, to lugnet.robotics.handyboard)
| | | | | Re: zxt614,rue250
|
| (...) A quick check reveals that a replacement part for the polyswitch fuse is 60R250 (Littelfuse) or the Bourns MF-RX250...I'm sure there are others. If you can't find one of these resettable fuses, you could likely use any 5amp fuse and just (...) (27 years ago, 12-May-99, to lugnet.robotics.handyboard)
|
|
