 | | help about part C3
|
|
Can anyone tell me of a good place to get part C3 for the handy board?...DigiKey no longer has it or a replacement. -Jon Schuck (27 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | Has anyone an icb-routine for 9600b serial connection ?
|
|
Hi, i used the serialio.c routines to establish a data connection between the Handyboard and a Linux PC and encountered the same problems already mentioned in the mailing list: 1) Only char by char transmission with sleeps between transmissions (...) (27 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Servo DEinitialization.
|
|
Sorry. I'll reread the documentation. I was going by memory. Fred G. Martin Fred G. Martin (...) Ross Tonkens (27 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Servo DEinitialization.
|
|
(...) as it says in the docs: init_expbd_servos(int action) If action is zero, servo control signals are disabled. If action is non-zero, servo control signals are enabled. Control signals are disabled by default every time the Handy Board is reset. (...) (27 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Servo DEinitialization.
|
|
I'd go for the Coke can idea. Sounds like a surer shot. I thought init_expbd_servos(x), where x = integer from 0 to 5, was used to initialize the servos individually. Stupid me. I've been using init_expbd_servos(5), and, since I only had #5 hooked (...) (27 years ago, 13-Apr-99, to lugnet.robotics.handyboard)
|
