 | | Re: Desgning H-bridge
|
|
Another great source for h-bridge design if (URL) It gives details on how to build a PIC based motor controller, but more importantly, it has a great h-bridge schematic. Be sure to check it out. ---...--- Brian Schimpf schimpfy2@aol.com (25 years ago, 12-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | Rangingproblems with Sharp GP2D02
|
|
Hi all I just finished rewriting the GP2D02 routines by Kent. Seems all to work just fine....except that I don't get readings below around 55. Even if I don't have anything in front of the sensor (dist. to wall more than 2m) I never get a reading of (...) (25 years ago, 12-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Desgning H-bridge
|
|
Hey Ericson, Check out the following sites for motor control information: (URL) under motor control Hope this helps, good luck! --kam (URL) Mon, 12 Apr 1999, MAR ERICSON wrote: -->Where can we get info in designing H-bridges from descreet (...) (25 years ago, 12-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | Desgning H-bridge
|
|
Where can we get info in designing H-bridges from descreet components? Is it sufficient to use just four MOSFETs or just four solid state relays? Thanks for any input. ---...--- ericson mar Robotics Consultant mar@cooper.edu (212)353-4356 Department (...) (25 years ago, 12-Apr-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Smooth PWM for IC3.2?
|
|
(...) This problem is the only reason why I'm not buying the commercial version of IC. I'd buy in an heartbeat if *all* the code running on the handy board was available. Until then I stick with the free version. So far I've modified my pcode at (...) (25 years ago, 12-Apr-99, to lugnet.robotics.handyboard)
|
