 | | Re: Hamamatsu P5587
|
|
I'm not an ASCII artist, so I'll attempt a verbal description. View the P5587 with the emitter/detector side facing you and have two pins on the left and three on the right. In this position pin-1 is in the upper left corner, pin-2 in the lower (...) (26 years ago, 4-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Hamamatsu P5587
|
|
Does anybody have the pinouts or spec sheet for the Hamamatsu P5587 optical sensor? Thanks (26 years ago, 4-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Sharp GP2D02 code available
|
|
Thanks Barry, great work. I do have one little question: As I read the data sheet of the GP2D02 ( (URL) ) I saw some timing specifications that i think are not taken care of in your software. Please correct me if I'm wrong. The timing chart shows (...) (26 years ago, 4-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Re: Precise timing with the Handyboard ?
|
|
(...) Use the TIC port 2 or 3. The precision of the reading you'll get is 0.5 us. About a year ago I posted some drivers to make such measurements. Tell me if you want them. cu Tom -- Thomas Hauri ZHW Zuercher Hochschule Winterthur University of (...) (26 years ago, 4-Mar-99, to lugnet.robotics.handyboard)
|
| |
| | Precise timing with the Handyboard ?
|
|
Hi, does anybody know how to measure the time between two trigger signals as precise as possible ( around 10 microseconds would be fine.) with the handyboard. Peter -- Dr. Peter Borrmann University of Oldenburg Phone: +49 441 798 3362 (office) (...) (26 years ago, 4-Mar-99, to lugnet.robotics.handyboard)
|
