 | | First steps ok
|
| Hi! I'm extremely happy today, that I could start mounting my Hand Board. The reset chips arrived and now the only thing that's missing is the lcd, but it should arrive by next Monday. I've mounted the serial comm board and it worked ok, and I've (...) (28 years ago, 1-Feb-99, to lugnet.robotics.handyboard)
| | | | | unsubscribe
|
| <smaller><smaller>I would like to unsubscribe the mailing list Thank you <nofill> (28 years ago, 1-Feb-99, to lugnet.robotics.handyboard)
| | | | | hall effect sensor
|
| hello i use hall effect sensor to check velocity (wheel) of car test(toy) when the wheel stops,that velocity is 0 m/s,i use this value to back my car. using handy board to control it i don't know about connecting hall effect sensor on handyboard. (...) (28 years ago, 1-Feb-99, to lugnet.robotics.handyboard)
| | | | | Re: ** voltage dropping and current limitting**
|
| Dear Mike, I believe the 16 V is rms value. If you attach a capacitor across the bridge rectifier under no load condition(output terminals are open), the capacitor gets charged not to 16 V rms but to the maximum value ie Vm=16*2^0.5 which is about (...) (28 years ago, 30-Jan-99, to lugnet.robotics.handyboard)
| | | | | Re: HB failure
|
| (...) Thanks for your response. When we load the pcode_hb.s19file with the right CONFIG it seems to load properly. We then turn the HB off and back on and try to load the Interactive C. This does not work at the computer says "attempting to linkt to (...) (28 years ago, 30-Jan-99, to lugnet.robotics.handyboard)
|
|
