 | | Re: Question on analog()....
|
|
(...) Right; a voltage divider probably biases the microphone amp ckt at 2.5v. schematics are provided, no? -F (28 years ago, 5-Jun-96, to lugnet.robotics.handyboard)
|
| |
| | Re:Re: Question on analog()....
|
|
(...) Are you sure about this? On page 49 of my copy, it states pretty clearly that the input range is 0 to 5 v. ---...--- Just returned home. I checked the IC Manual of "The Mobile robot Assembly Guide" for the Rug Warrior. On p.66, it reads "When (...) (28 years ago, 5-Jun-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Question on analog(). Negative voltage
|
|
(...) DO NOT SEND NEGATIVE VOLTAGES INTO THE 6811, you will destroy the analog input circuit. Any voltage outside of the 0 to 5 v range is hazardous, unless it is current-limited to a few milliamps. (...) Are you sure about this? On page 49 of my (...) (28 years ago, 5-Jun-96, to lugnet.robotics.handyboard)
|
| |
| | Question on analog(). Negative voltage
|
|
Last time, I learned that the values of analog() corresponds to the voltage between 0 and 5. What if the signal to the analog port is a negative voltage. For example, -2 volt ? In that case, does that mean I have to use another formula or make some (...) (28 years ago, 5-Jun-96, to lugnet.robotics.handyboard)
|
| |
| | encoders??
|
|
Let's see. First, I'd like to put a pair, if possible, of shaft encoders on my robot. (It's annoying not being able to tell how far I've gone!) Anyways, digital inputs 7 and 9 are being used by a 6500 Polaroid sensor and an RC servo. Is it still (...) (28 years ago, 5-Jun-96, to lugnet.robotics.handyboard)
|
