 | | encoder and motor questions
|
|
dear viewers here are some questions i need to ask: 1) my DC motor comes with a 10 pin optical encoder(supply current-10mA) pin 1- GND pin 2- Vcc pin 3- dir pin 4-standyby pin 5 and 6 - A1 and A2 pin 7 &8 - B1 and B2 pin 9 and 10 - Z1 and Z2 how do (...) (28 years ago, 23-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | expansion board - servo control
|
|
Hello, I emailed this to the handy board list and got one response. I am mailing it back hoping that I can get some more responses from those on the list and perhaps fred. (...) (28 years ago, 23-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | charger board problem ( URGENT)
|
|
hI Anthony and others, I just plug in the RJ11 in the HD and charger board. It supposed that the red LED on the charger board should light up. It failed to light up. When I plug in the adaptor onto the charger board, the red LED light up but NOT the (...) (28 years ago, 23-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | RE: expansion board - servo control
|
|
I also saw a similar problem while experimenting with an Atmel microcontroller and a Futuba servo. My problem ended up being that I had forgotten to have a common ground between the controller and the servo. Once I connected the grounds everything (...) (28 years ago, 23-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | new 6811 Downloader for PowerMac G3's!
|
|
Hi everyone, I've built a new version of a 6811 Downloader application for Mac that works fine with PowerMac G3's. (It also works with older Macs.) You can download it from the Handy Board home page: (URL) (28 years ago, 22-Dec-98, to lugnet.robotics.handyboard)
|
