 | | expansion board - servo control
|
|
Hi, I stopped working with the handyboard for a while but just started back up again. I put the expansion board onto my handyboard and began testing it. After testing the general tests done before with just the handyboard I started testing the servo (...) (26 years ago, 21-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | unable to download P_code
|
|
Hi everybody, When the one end of the RJ11 cable plug into the RJ12 side entry(J10), it supposed the red LED on the charger board will light up. However, it failed to light up. Hence, this made the booststrap failed and I unable to download the (...) (26 years ago, 21-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | FW: change of address
|
|
-----Original Message----- From: Jaron Paludanus [mailto:j.paludanus@....a2000.nl] Sent: donderdag 17 december 1998 23:58 To: Fred G Martin Subject: change of address I'm not sure my previous mail came through but I have gone high-speed by cable (...) (26 years ago, 21-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | Unable to download P_code
|
|
Hi everybody, When the one end of the RJ11 cable plug into the RJ12 side entry(J10), it supposed the red LED on the charger board will light up. However, it failed to light up. Hence, this made the booststrap failed and I unable to download the (...) (26 years ago, 21-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | Help Needed -Reply
|
|
You don't need to put that code into eeprom. Just put the code inside a main() function block like this: void main(void) { YOUR CODE } Be sure and include the start button logic at the start of your code. The handyboard with start and automaticly (...) (26 years ago, 21-Dec-98, to lugnet.robotics.handyboard)
|
