 | | communication between two boards
|
|
I use handy board and xc40 board(It has xc4010 FPGA chip) The problem is that they must communicate each other. But I don't know how I can make them communicate. In Q&A(at mit's handy board home page) it says that SPI pin can be used as digital (...) (26 years ago, 7-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | spo256
|
|
Does anyone know who sell's the SPO256 and CTS256A-AL2 IC's (26 years ago, 7-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | Re: hbdl.exe download prob
|
|
Shiva, When the Windows hddl.exe complains that it cannot open the port, it is usually due to another Windows programming using / holding that serial port. Try all the comm ports to see if hbdl.exe allows it to open one of them, then attach the (...) (26 years ago, 6-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Two Way Radio question
|
|
I would think so, assuming that you keep the data rate relatively low (IMHO, 9600 bps would probably be pushing it, 2400 may be better) --phil (...) (26 years ago, 6-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Two Way Radio question
|
|
I am using a rug warior pro whose brain is very similar to the Handyboard and would like to know if these VHF radio Data Modules could be set up between the computer serial port and the Rug Warrior brain to provide a radio link instead of the 4 wire (...) (26 years ago, 6-Dec-98, to lugnet.robotics.handyboard)
|
