 | | Line follower kit
|
|
I was wondering if anybody had used the Line follower kit from the robotstore? Is it pretty much plug and play (besides a little programming) for the handyboard? Thanks. Dave (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: DC motor voltage source
|
|
Philip: I depends on how many motor driver ports you want to have on the new voltage. If you have just two motors, then lifting (and wirewrapping) pin 8 for one chip whould be enough. The motor outputs affected are nearest to the chip modified. I (...) (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Voltage for the DC motor
|
|
Ja, I could not tell you for the life of me what 'type' f a HB it is, but I remember someone once telling me that you could just remove one of the pins from the driver chip instead. This method would be less final (ie, just bend the lead up and if (...) (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: programming help.
|
|
The "<<" is a shift left operator in C 0E is the actual motor port on the Handy Board. (...) mean? (...) between 4 and 7. (...) peek(address) | value). I don't have any documentation here, so I don't know what is stored in 0x0e, but it could be the (...) (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Bend/ Flex Sensor
|
|
I think its cheaper to get an old Nintendo power glove and Hack it! (...) (26 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
