 | | Re: DC motor voltage source
|
|
Philip: I depends on how many motor driver ports you want to have on the new voltage. If you have just two motors, then lifting (and wirewrapping) pin 8 for one chip whould be enough. The motor outputs affected are nearest to the chip modified. I (...) (28 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Voltage for the DC motor
|
|
Ja, I could not tell you for the life of me what 'type' f a HB it is, but I remember someone once telling me that you could just remove one of the pins from the driver chip instead. This method would be less final (ie, just bend the lead up and if (...) (28 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: programming help.
|
|
The "<<" is a shift left operator in C 0E is the actual motor port on the Handy Board. (...) mean? (...) between 4 and 7. (...) peek(address) | value). I don't have any documentation here, so I don't know what is stored in 0x0e, but it could be the (...) (28 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Bend/ Flex Sensor
|
|
I think its cheaper to get an old Nintendo power glove and Hack it! (...) (28 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
| |
| | Re: IR Detection
|
|
Hi Most of the IR LED's sold at Radio Shack are the 840-880 nm wavelenght type. The Sharp tin can requires the 940 nm wavelength IR beam if my memory serves me right, it also requires to be modulated at 38 or 40 kHz depending on the model. This 38 (...) (28 years ago, 2-Nov-98, to lugnet.robotics.handyboard)
|
