| | Re: voltage regulator current rating
|
|
(...) Is there any current going directly into GND from the LM2931Z-5.0? If so, would this cause any "extra" heat other than from the current the HB draws? -Eric (28 years ago, 16-May-96, to lugnet.robotics.handyboard)
|
|
| | SPI Bus problem solved!!!!!!
|
|
Hi-dee ho, I'm happy to report that I've successfully gotten a Handyboard to communicate to a Miniboard via the Synchronous Serial bus (SPI). The secret was (as I alluded to in my last post on the subject) setting the DDRD (Data direction for port (...) (28 years ago, 16-May-96, to lugnet.robotics.handyboard)
|
|
| | Available J sockets on Hboard?
|
|
Are there any unused sockets on the Handyboard? For example, the bottom 2 sockets in J6 look to be unused, and I could use a couple of sockets to bring out some signals. Now that the thing is assembled, it's difficult to follow traces on the top (...) (28 years ago, 15-May-96, to lugnet.robotics.handyboard)
|
|
| | Thanks for all the replys on the L293D
|
|
Thank you Best regards Jakob Lunderg (28 years ago, 15-May-96, to lugnet.robotics.handyboard)
|
|
| | Re: Downloading without AC adapter
|
|
(...) Yes. The interface will draw power from the HB's battery. Don't leave the HB plugged into the interface w/o the adapter for extended periods, because the interface will drain the HB's battery even if the HB is switched off. -Fred (28 years ago, 15-May-96, to lugnet.robotics.handyboard)
|