 | | 68hc11F1
|
| Hello all, Thanks for all the replies that you have send. My board is now working, at 16 mhz with flash and ram. Richard (28 years ago, 27-Jul-98, to lugnet.robotics.handyboard)
| | | | | RE: fischertechnik
|
| First of all, the HandyBoard works fine with fischertechnik. I've been using fischertechnik for a variety of purposes since about 1980. I've also used Lego Technic, although less extensively, for ten years or so. Size/Scale: If you build identically (...) (28 years ago, 27-Jul-98, to lugnet.robotics.handyboard)
| | | | | Re: troubleshooting
|
| In your message you said: (...) good.... (...) yes, this is normal -- before you load pcode_hb.s19, the LCD is just as you describe. (...) d (...) I'm not clear the problem. if you enable "ignore feedback", does it then download properly? if so, (...) (28 years ago, 27-Jul-98, to lugnet.robotics.handyboard)
| | | | | troubleshooting
|
| I have a problem assembleing my hanyboard. I am at the stage where i am doing the digital input circuit. Before this I successfully loaded pcode_hb.s19 into the handyboard and the interactive C message appeared. However, before i loaded pcode_hb.s19 (...) (28 years ago, 27-Jul-98, to lugnet.robotics.handyboard)
| | | | | Re: motor power problems
|
| in short, the answer is: "you can't use 3 to 4v motors with the Handy Board." basically, these motors are cheap toy motors that are incredibly noisy from an electrical standpoint, plus they want to draw far more current than the Handy Board's motor (...) (28 years ago, 25-Jul-98, to lugnet.robotics.handyboard)
|
|
