 | | RE: Walking robot - Related Topic
|
| Mike, I have actually seen only 3 reasonable quality walkers on the market (the 6 legged kind) but I have to admit that I haven't searched that far recently. Lynxmotion ((URL) do one which looks to be pretty good quality however it is a bit (...) (28 years ago, 18-Jun-98, to lugnet.robotics.handyboard)
| | | | | RE: System interupt problems?
|
| Tim, I just scanned your code, so I might have missed it, but don't you have to clear (or set) a flag in your interrupt routine to reenable the TOC4 interrupt? Mike ---...--- From: Timothy B. Gold[SMTP:goldt@ee.byu.edu] Sent: Wednesday, June 17, (...) (28 years ago, 18-Jun-98, to lugnet.robotics.handyboard)
| | | | | Re: Handy Board Header
|
| I once ordered male ED7xxx series and they work ok. I do like them. I never tried the female ones. According to HB manual, the Digi-Key parts are: 929974-01-36-ND - female 36 pins. 929834-01-36-ND - male 36 pins. Regards, -Pandit ---...--- (...) (...) (28 years ago, 18-Jun-98, to lugnet.robotics.handyboard)
| | | | | Re: Hot Wire Anemometers
|
| (...) Actually, I'd want to modify the curve. Stock, the cars run very rich. For people interested in getting the most hp out of them, we'd want to be able to lean the engine out a bit (along with reducing the intake restriction). But this is (...) (28 years ago, 18-Jun-98, to lugnet.robotics.handyboard)
| | | | | Re: Hot Wire Anemometers
|
| (...) Not to mention that the sensor that is already built-in to the car is probably non-linear as well, which means that the software in the car's computer is already set up for that specific curve. If you were to replace it with another (...) (28 years ago, 17-Jun-98, to lugnet.robotics.handyboard)
|
|
