 | | Moder Identification Needed
|
|
I have a couple of nice motors that I would like to get some info on. They were removed from some medical recording devices. They are very small and have pretty good power. If you try to stop the motor by grabbing the bushing on the shaft, it is (...) (26 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | RE: Cheap air flow sensor
|
|
The classic small air flow sensor is a hot-wire-anemometer. Just position a short piece of very fine wire in the airflow and normal to it, run a constant current thru it, and measure the voltage change due to the cooling effect of the airflow. Works (...) (26 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Cheap air flow sensor
|
|
Elektor had published a similar circuit for detecting air leaks. The heated transistor and another transistor acting as temp. sensor were glued together using heatsink compound. You had then to nullify/calibrate a meter at ambient temp. when the (...) (26 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Re: handyboard reset vector
|
|
Hi Justin, I believe the previous mail indicates assembly the code rather. This would be the generating the "p code" of the handy board rather than the actual IC code. Regards, -Pandit ---...--- (...) using (...) (26 years ago, 16-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Cheap air flow sensor
|
|
We have used model boat propellers on a ballbearing and on a brass bushing. Keep the bearing or bushing well lubricated for good sensitivity at low air volume (ie: low speed of the propeller). We used the propeller mounted in 1.5 inch and 2 inch PVC (...) (26 years ago, 15-Jun-98, to lugnet.robotics.handyboard)
|
