 | | Re: config 0x0C
|
|
From: Alf Kuchenbuch <alfk@eikon.tum.de> (...) The 0x0C value represents EEPROM OFF, ROM OFF. A related question that I have is that I'm using the 811E2 and the hbdl program will only work if I use 0xFF. Which places EEPROM ON and at the upper most (...) (28 years ago, 15-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Remote Controller Needed
|
|
I have a Sony IR Remote but it is a little large. I'm wondering if someone knows of a Remote Control Unit that is very small that will work with the sony-ir.icb code. I'm thinking maybe one the size of the ones used with camcorders but don't know (...) (28 years ago, 15-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | r22 Code
|
|
I am using a Sony IR and also use the sony-ir.icb code. But I am curious what is the r22 ir code for? I also understand that if I use the sony-ir that I should not use the r22 but I'd like to know what it is for anyway. (28 years ago, 15-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Re: HandyBoard Reset Vector
|
|
(...) Hi! If you start the Handyboard (no bootstrap mode) it is in the 'special test' mode. So the start vector is located at $BFFE and $BFFF. In your assambly program use the following code: Start_vec ORG $BFFE FDB Program_Start where (...) (28 years ago, 15-Jun-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Tone Functions
|
|
yep, 5 kHz is about the top end of the HB's 6811 capability. going higher would require dedicating the 'hc11 to generating the tone and doing nothing else. why? interrupt routine overhead. takes a bunch of cycles to handle an interrupt. the tone (...) (28 years ago, 15-Jun-98, to lugnet.robotics.handyboard)
|
