 | | Where can I find spec. of the LM052L
|
|
I have an equivalent LCD screen (sharp L16255), I think, but it is a bit different from the LM052L and I am not sure how to interface it to the handy board. I cannot find any spec. on neither of these LCD screen and just need a hint maybe. Thanks (...) (26 years ago, 22-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: important update to Handy Board standard libraries.
|
|
(...) You must manual consolidate the new driver with the smooth-pwm libraries. To consolidate, 1. edit the smooth-pwm lib_hb.c, and remove the function "_raw_analog()", 2. install the new lib_hb.icb file in your IC lib directory (this contains the (...) (26 years ago, 20-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: important update to Handy Board standard libraries.
|
|
Will this new lib_hb.c also replace the Smooth PWM lib_hb.c released by Newton Labs? It appears not. What is the easiest way to consolidate the Smooth PWM routines with your improved analog code? Cheers, Skye. +---...---+---...---+ | Skye Legon | (...) (26 years ago, 20-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Addresses of SPI ports
|
|
Hi Arthur, The SPI expansion header is shown below: ---...--- Pinouts: 1 Gnd | 2 | 1 | 2 Vcc 5V | 4 | 3 | 3 SS* | 6 | 5 | 4 MISO | 8 | 7 | 5 SCK ---...--- 6 MOSI 7 & 8 Not connected I assume you will be using the Handy Board as a MASTER device not a (...) (26 years ago, 20-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Addresses of SPI ports
|
|
Hi The SPI Header is connected to port D of the hc11 as follows: Port D Bit 2 - PD2 - MISO Port D Bit 3 - PD3 - MOSI Port D Bit 4 - PD4 - SCK Port D Bit 5 - PD5 - SS All of those pins can be used for general-purpose I/O signals. To program port D (...) (26 years ago, 20-May-98, to lugnet.robotics.handyboard)
|
