 | | Re: Controlling a DC motor 3
|
|
(...) Within limits, the rate doesn't matter much. What matters is the ratio of off time to on time (i.e., the duty cycle). Probably, you could change the frequency by an order of magnitude either way and get about the same results. --Will , , __@_/ (...) (28 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: LCD Addressing - & - Expanded Mode
|
|
(...) You can only run the LCD when in single chip mode. (...) This leaves the chip in 'special test mode' that lets you go into and out of expanded mode by writing the config register. --Chuck (28 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Polarity of PowerJack from HB und Charger Board
|
|
on the interface/charger, since there's a bridge rectifier immediately normalizing the input jack voltage -- regardless of polarity -- it kind of doesn't matter which polarity you use. there is a discrepancy between the int/charger schematic and (...) (28 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Cannot download pcode on a Mac G3
|
|
Paul -- have you tried 6811 Downloader? Any luck with that? looks like Randy and I will both need to get our hands on a G3 to debug our code :-) Fred In your message you said: (...) (28 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
| |
| | Cannot download pcode on a Mac G3
|
|
Hello everyone, I've been having a problem downloading pcode to a handyboard or rugwarrior board from my Mac G3 (266 Mhz desktop model). When I try to download the bootstrap code, it reports that the bootstrap failed after 000 bytes, etc.. etc... (...) (28 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
