Subject:
|
Cannot download pcode on a Mac G3
|
Newsgroups:
|
lugnet.robotics.handyboard
|
Date:
|
Sun, 3 May 1998 22:07:45 GMT
|
Original-From:
|
Paul E. Rybski <rybski@cs.umn.NOMORESPAMedu>
|
Viewed:
|
1577 times
|
| |
|
|
Hello everyone,
I've been having a problem downloading pcode to a handyboard or
rugwarrior board from my Mac G3 (266 Mhz desktop model). When I try to
download the bootstrap code, it reports that the bootstrap failed after
000 bytes, etc.. etc... The funny thing is that I am able to
communicate with either the rug warrior or handyboard just fine as long
as they both have working pcode installed in them already. I am using IC
version 3.1 and have found this behavior to be the same for both the
modem and the printer port.
I have also found that when I try to change the definitions file
in the preferences menu to download different pcode and libraries to the
handyboard or rug warrior, IC crashes usually during the second
configuration swap.
I thought that I'd try using IC 2.852 to see if I would get
better behavior. Here's a transcript of the failed download:
Please place board in download mode and press RETURN
To quit, press Q
For help, press H
Downloading 256 byte bootstrap (229 data)
................................................................
................................................................
................................................................
.....................................___________________________
Timeout on serial receive. 256 chars left to receive
Perhaps the board was not connected properly or not in download mode
Please place board in download mode and press RETURN
To quit, press Q
For help, press H
Has anybody else had similar problems? Randy or Fred, any ideas
as to why IC doesn't like my Mac G3? I'm running system 8.1, BTW.
-Paul.
|
|
Message has 3 Replies:
 | | Re: Cannot download pcode on a Mac G3
|
| I have a 266 G3 minitower, and I have the identical problem. The only way to solve this is to let IC die, not reset the HB and then run IC again. It complains to can't talk to the HB, and then I reset the HB and all works fine. Kinda odd, but it (...) (27 years ago, 4-May-98, to lugnet.robotics.handyboard)
|
Message is in Reply To:
| | recharging a battery the right way
|
| hello I have a 6v 2.0amp battery. Its a lead acid battery. What is the right way to recharge it? The reason I ask is because I had a 12v 7amp battery from the same manyfacturer. I charged it using a car battery charger at the lowest setting (...) (27 years ago, 3-May-98, to lugnet.robotics.handyboard)
|
5 Messages in This Thread:
  
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
