 | | Re: HBridge LMD18200
|
|
Its a MOSFET based bridge, the Vgs potential needed to put the FETs into full enhancement mode is 11.2v or thereabouts. At lower voltages the FETs operate in their linear range (their Rds value goes up) and they dissipate much more heat. (As Rds (...) (27 years ago, 20-Mar-98, to lugnet.robotics.handyboard)
|
| |
| | HBridge LMD18200
|
|
Hello, First thanks for your answers regarding H-Bridges and especially the LM18200. This H-Bridges would be used with 12V DC motors which can sink up to 12Amp each and I have plenty of room to put them. But there is still something that puzle me : (...) (27 years ago, 19-Mar-98, to lugnet.robotics.handyboard)
|
| |
| | IR input sensor
|
|
Hey! I was wondering if anyone has written any sort of fairly simple program that can detect another handyboard by using the IR input sensor. Does this require anything else besides maybe an analog IR sensor and the sensor on the board? If you could (...) (27 years ago, 19-Mar-98, to lugnet.robotics.handyboard)
|
| |
| | mailing list
|
|
Please remove me from your list> (27 years ago, 19-Mar-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Polaroid sonar connector
|
|
Easy solution. Why waste so much time looking for connectors. Just remove the connector and solder some wires to the board and run those wires to whatever kind of connector you want! -----Original Message----- From: Will Bain <willbain@cs.umt.edu> (...) (27 years ago, 19-Mar-98, to lugnet.robotics.handyboard)
|
