|
|
 | | pcode_hb.s19 downloading probs
|
| hello, I tryed to download the pcode_hb.s19 file using DL, When it starts sending it stops and says "expected 244, received 150, after 144 chars recieved" I cant seem to get any of the downloaders to work. Im a bit stuck on where the problems lies (...) (27 years ago, 18-Jan-98, to lugnet.robotics.handyboard)
| | | | | RE: M68HC711E9
|
| O.K, , I still have a question. I'm working with a handy board and it use a special mode to talk to a LCD. If i understand , the handy board need to put the reset vector in the range BFC0 - BFFF. If get the aplication note for the 711E9 and ,as it (...) (27 years ago, 17-Jan-98, to lugnet.robotics.handyboard)
| | | | | Still problems to boot handyboard.
|
| I still have problems with two handyboards. I can download the code but never boot my code (that code run in other handy, however) Other variant is if i put a 69hc11a1fn the handy download the initiatl bootstrap code , and when try to syncronize (...) (27 years ago, 17-Jan-98, to lugnet.robotics.handyboard)
| | | | | Re: Shaft Encoders
|
| (...) Hi there, Would these chips be suitable for interfacing a mouse to the Handyboard? My robot incorporates a mouse as a castor wheel and I want to use its shaft encoders as position/velocity sensors (relative) for the robot, but I don't know (...) (27 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
| | | | | Re: Shaft encoder
|
| (...) Hi there, Would these chips be suitable for interfacing a mouse to the Handyboard? My robot incorporates a mouse as a castor wheel and I want to use its shaft encoders as position/velocity sensors (relative) for the robot, but I don't know (...) (27 years ago, 16-Jan-98, to lugnet.robotics.handyboard)
|
|
