 | | more address lines on expansion board
|
|
Hi Brian, When Fred and I designed the Rev 2.0 6.270 controller, we consciously made the expansion bus small and simple. For most expansion devices, the pre-decoded chip selects make more sense than sending all the address lines, since the latter (...) (28 years ago, 8-Apr-96, to lugnet.robotics.handyboard)
|
| |
| | Pcode instructions?
|
|
OK. I know this is going to be a long shot, but here goes: Are there any docs on the pcode? I.e. is there some way that I can learn what I need to learn to modify the source code pcode.asm besides reading the file pcode.asm and tearing my hair out? (...) (28 years ago, 8-Apr-96, to lugnet.robotics.handyboard)
|
| |
| | Re: Handyboard expansion status
|
|
(...) I don't have one of the beta versions of the expansion board, but I've been building my own expansion boards and putting them on the HB. One thing that I've found is problematic with the HB design, in regards to expansion board design, is that (...) (28 years ago, 7-Apr-96, to lugnet.robotics.handyboard)
|
| |
| | http://lcs.www.media.mit.edu/groups/el/projects/handy-board/maillist.htm
|
|
i would like to use the list. thankyou, Jeff (28 years ago, 7-Apr-96, to lugnet.robotics.handyboard)
|
| |
| | mseconds
|
|
Is there a way to get sub-milisecond times measured with the handyboard? I was thinking of trying to modify msecond but I can't look at it now that it is a primitive. Dirk (28 years ago, 7-Apr-96, to lugnet.robotics.handyboard)
|
