|
|
 | | (no subject)
|
| I'm able to compile version 2.861 with Kent Farnsworth setup, but not ver 3.1 of the P-code. Has anybody been able to do this? I get a lot of phasing errors when I try. There is a problem with the current LCD initialization routine I would like to (...) (27 years ago, 4-Sep-97, to lugnet.robotics.handyboard)
| | | | | Re: Serial routines
|
| [Jodi Seaborn] spake unto the ether: (...) Hi Jodi, the serial input routines (i.e., from some other source to the Handy Board) do work, it's just that the I/O is polled, not interrupt-driven. Thus, unless the device sending characters sends them at (...) (27 years ago, 4-Sep-97, to lugnet.robotics.handyboard)
| | | | | Re: DC adapter
|
| Good question. Answer: DO NOT USE REGULATED ADAPTERS WITH THE HANDY BOARD. I will add this to the FAQ, because it is not obvious, but the HB power circuitry was designed explicitly for CHEAPO UNREGULATED WALL WARTS ONLY. sorry, Fred In your message (...) (27 years ago, 4-Sep-97, to lugnet.robotics.handyboard)
| | | | | DC adapter
|
| Hi all, Just another (hopefully unanswered) question about the DC adapter: Do the specifications stated in the FAQ (18 volts unconnected) also apply to _regulated_ adapters, or only to unregulated? I'm asking this because I just bought a new (...) (27 years ago, 4-Sep-97, to lugnet.robotics.handyboard)
| | | | | (no subject)
|
| I'm able to compile version 2.861 with Kent Farnsworth setup, but not ver 3.1 of the P-code. Has anybody been able to do this? I get a lot of phasing errors when I try. There is a problem with the current LCD initialization routine I would like to (...) (27 years ago, 4-Sep-97, to lugnet.robotics.handyboard)
|
|
