 | | Re: LM34 temp sensor to handy board?
|
|
Jeff, I used a couple of the 10mV/deg Kelvin ones, with nothing more than the current load resistor, ie no amplification at all. For example, freezing point = zero celcius = 273 Kelvin = 2.73 volts. With the 6811 resolution of about 20 mV (5v / (...) (27 years ago, 22-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | headers
|
|
This may sound like a dumb question, but I don't know where to get headers. Digi Key has some but 4 different kinds. The parts list says nothing except 14 pin female header. Nothing else. Where did you get your headers and what are the part numbers? (27 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | Re: Servo control using Miniboard slaved
|
|
Chuck: I agree with you; what I've done with the MiniSSC is to break the path into a set of linear segments with via points in joint space. The lynxmotion arm ends up needing a lot of points (therefore moving pretty slowly) to avoid jerkiness, but (...) (27 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | Re: LCD display
|
|
(27 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
| |
| | Re: LCD display
|
|
Hi. Give me the location and phone number to this place that you can order them and I will consider ordering several and selling them off individually. Scott sherman@plains.nodak.edu CSG ITS NDSU (...) (27 years ago, 21-Jul-97, to lugnet.robotics.handyboard)
|
