|
|
 | | Re: battery voltages
|
| Where on the Handy Board would you plug the 6V into? and what is the J13 connector for? -John (...) (29 years ago, 6-Feb-96, to lugnet.robotics.handyboard)
| | | | | Re: hmph
|
| why not use the cars drive electronics, just bypass the radio part, it would take a little work to find the points where the motors are turned on, but it should work. Just watch out for other people with remote control units. (...) (29 years ago, 6-Feb-96, to lugnet.robotics.handyboard)
| | | | | Enable interrupts within IC?
|
| Hi all, I'm trying to use IC to poke in an interrupt routine (the IC3 interrupt from pin PA0) assembled using PCBUG11 at $B600. I can set all the register bits correctly, but I can't execute the CLI (general interrupt enable) HC11 opcode from within (...) (29 years ago, 6-Feb-96, to lugnet.robotics.handyboard)
| | | | | driving 3v motors
|
| (...) The best solution here is to replace the HB's 9.6v batt with a 6v one. Once you get past the L293's, you'll be giving around 4v to the motors, which should be fine. -F (29 years ago, 5-Feb-96, to lugnet.robotics.handyboard)
| | | | | Re: Some quest. for details
|
| (snip) (...) You will tend to get a lot of flickering if you do not place a sleep() command in your loop that writes to the screen because the screen is being redrawn too quickly. Tom ___...___ Tom Cicatelli cica@tiac.net Melrose, Massachusetts (...) (29 years ago, 5-Feb-96, to lugnet.robotics.handyboard)
|
|
