 | | Re: Motor Speeds
|
|
(...) When I built the PWM controller out of a PIC I gave it 100 speeds representing 0 - 100% width. So a speed of 50 is a 50% duty cycle signaal. The disadvantage of the Handiboard scheme is granularity. In particular I have found that for really (...) (28 years ago, 25-Feb-97, to lugnet.robotics.handyboard)
|
| |
| | Re: IR Collision avoidance
|
|
(...) OK. (...) The transmitter is basically a modulator made from two 555 timer chips. One timer does 200-1000 Hz (we use 500) while the other does 38 KHz. On a scope, the output looks somewhat like.. |||...||| |||...||| |||...||| | | | | | | | | | (...) (28 years ago, 25-Feb-97, to lugnet.robotics.handyboard)
|
| |
| | Re: IR collision avoidance
|
|
Some comments and a few questions for Chris (...) We have "forward" and 45 degrees right". We wall hug to the right while you hug to the left. We ignore IR to left and use only the left contact switch for collisions (rare). (...) We had way too much (...) (28 years ago, 25-Feb-97, to lugnet.robotics.handyboard)
|
| |
| | Re: IR Collision avoidance
|
|
The Handyboard has a circuit (U7a, R4, C6) that generates a 38KHz signal. That drives an amplifier that then goes to J7, the IR LED output. If you hookup an IR LED to this jack (with a series resistor) then when you turn on TOC2 using ir_xmit_on() (...) (28 years ago, 24-Feb-97, to lugnet.robotics.handyboard)
|
| |
| | Re: IR collision avoidance
|
|
(...) I don't have the RS part numbers, but I bought them within the last few months so if there are "old" and "new" ones mine are probably "new". I checked out the RS web page and found that what they currently have is RS part number 276-137, and (...) (28 years ago, 24-Feb-97, to lugnet.robotics.handyboard)
|
