 | | reverse video in IC?
|
|
Is it possible to use printf to display reverse video on the handy board's LCD screen? I'm thinking about creating a menu system for my robot, and inverse video would be nice... Just curious! (29 years ago, 11-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | Max poke rate?
|
|
Hi, I've been trying to write to PD2 using the following: int write_port(int port, int value, int mask) { poke(port,(value & mask)|(peek(port) & ~mask)); } It works fine except that the fastest cycle that I can get out of PD2 is about 242 Hz. I need (...) (29 years ago, 11-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | synchronization problem with old IC
|
|
Hi Will, I'm assuming that you're using IC 2.81 on an IBM PC? One possible cause is that since IC 2.81 is a DOS program, the serial communication routines for old IC is flakey under a DOS box under Windows. Please run with the window in full-screen (...) (29 years ago, 11-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | Occasional Problem
|
|
I have a problem, which is more an inconvienve. At first my HB does not load IC correctly. But after five or so repeats of the below procedure, it works like it should: dl pcode_hb.s19 Everything is OK here. ic Below is reported: Attempting to link (...) (29 years ago, 11-Mar-96, to lugnet.robotics.handyboard)
|
| |
| | Re: hbdl users -- please check in
|
|
I used hbdl.exe from windows 96 to download pcode_hb.s19 and it worked just fine. Here are the details about my system. I downloaded through COM1: PENTIUM P5/100 (Gateway 2000 system) Windows 95 68HC11A1FN Thanks Ram. (...) ---...---Dr. M. K. (...) (29 years ago, 11-Mar-96, to lugnet.robotics.handyboard)
|
