Subject:
|
Re: CyberMaster connection to BricxCC
|
Newsgroups:
|
lugnet.robotics.cybermaster
|
Date:
|
Sat, 23 Apr 2016 09:37:38 GMT
|
Viewed:
|
33384 times
|
| |
|
|
In lugnet.robotics.cybermaster, "Graham Hepworð" <terminal0@protonmail.ch>
wrote:
> Hello, I am a new user to the Bricx Command Center.
>
> Forgive me if bad English. I seek to connect my CyberMaster unit to Bricx
> Command Center, though I get the error "No connection to the programmable brick"
> upon each time started. I use the original CyberMaster tower connected via a USB
> to serial adapter to my computer. My computer is 64bit and Windows 10. I have
> heard of success in connecting to this brick and using Bricx Command Center. Any
> helpful advice?
>
> Thank you,
>
>
> --Graham Hepworð
Answer: It is simple: I used the prolific usb to serial adapter, configured the
Serial communication to 9600,8,n,xon/xoff , took a NULL-Modem Serial Cable and
linkt pin 4 and 6 on the 9-pin connector together. After that communication to
the brick succeded on windows 10 for me. May this helps out
|
|
Message is in Reply To:
 | | CyberMaster connection to BricxCC
|
| Hello, I am a new user to the Bricx Command Center. Forgive me if bad English. I seek to connect my CyberMaster unit to Bricx Command Center, though I get the error "No connection to the programmable brick" upon each time started. I use the original (...) (9 years ago, 27-Feb-16, to lugnet.robotics.cybermaster)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
