Subject:
|
CyberMaster connection to BricxCC
|
Newsgroups:
|
lugnet.robotics.cybermaster
|
Date:
|
Sat, 27 Feb 2016 21:40:24 GMT
|
Viewed:
|
34731 times
|
| |
|
|
Hello, I am a new user to the Bricx Command Center.
Forgive me if bad English. I seek to connect my CyberMaster unit to Bricx
Command Center, though I get the error "No connection to the programmable brick"
upon each time started. I use the original CyberMaster tower connected via a USB
to serial adapter to my computer. My computer is 64bit and Windows 10. I have
heard of success in connecting to this brick and using Bricx Command Center. Any
helpful advice?
Thank you,
--Graham Hepworð
|
|
Message has 2 Replies:
 | | Re: CyberMaster connection to BricxCC
|
| (...) Answer: It is simple: I used the prolific usb to serial adapter, configured the Serial communication to 9600,8,n,xon/xoff , took a NULL-Modem Serial Cable and linkt pin 4 and 6 on the 9-pin connector together. After that communication to the (...) (9 years ago, 23-Apr-16, to lugnet.robotics.cybermaster)
| | | Re: CyberMaster connection to BricxCC
|
| (...) Answer: It is simple: I used the prolific usb to serial adapter, configured the Serial communication to 9600,8,n,xon/xoff , took a NULL-Modem Serial Cable and linkt pin 4 and 6 on the 9-pin connector together. After that communication to the (...) (9 years ago, 23-Apr-16, to lugnet.robotics.cybermaster)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
